How to Carve Angry Birds Pumpkin Carvings For Halloween?

Angry Birds Halloween Pumpkin Carvings will provide quality and style for your house. Interested of tradition halloween pumpkins, angry birds pumpkins feel funny more. Hold these handsome angry birds halloween pumpkins to party with your family. It's so interesting! These handmade angry birds pumpkins look astonishingly similar to their on-screen counterparts. If you're not as artistically minded, try enlarging stills or screencaps of the characters you'd like to replicate and print them out to use as stencils.

How to Carve Angry Birds Pumpkin Carvings For Halloween?

Now, let's study the way of Carving Angry Birds Halloween Pumpkin Carvings:

1、Preparation

For easy cleanup, place your pumpkin on several layers of newspaper before carving. Clean the outside of the pumpkin with a rag moistened with water to remove dirt and debris.

2、Draw and Cut Lid

Cut a six-sided lid, big enough so you can reach in and clean out all the pumpkin gunk. Angle a saw or knife toward the center of the pumpkin to create a ledge that supports the lid. Make sure the hole is large enough to reach in and pull out the seeds and stringy membrane. The bottom of the pumpkin could also be cut off instead; this will allow the pumpkin to sit up straight and make removing the seeds easier.

3、Clean and Scrape

Using an ice cream scoop or the special pumpkin scoop, clean out the seeds and strings. Where you plan to carve, scrape the pumpkin wall until it's about one inch thick. If carving a challenging pattern, scrape the pumpkin so that the wall is about one-half inch thick.

4、Print and Attach Pattern

Print the pattern and tape or pin it to your pumpkin. If you use pins, place them on the design lines so you don't end up with holes you don't want!

5、Transfer Design

Using a pushpin, or a poker tool, make pinpoint marks apart along the design lines. Check to see you have transferred the design completely, then take the pattern off the pumpkin.

6、Carve

Using the carving tools saw dot-to-dot using a gentle up and down motion. Saw gently, the saws can break if they are forced.

7、Locate the Chimney

Locate and cut a chimney for the candle. If a flashlight or battery candle is used, a chimney is not needed. Place the candle in the bottom of the pumpkin. If candle does not stand on its own, place it on a small, non-flammable plate or bore a small hole in the bottom of the pumpkin to hold the candle.